Page 1 of 1
framing
Posted: Mon Dec 10, 2012 9:03 am
by dawnnelson69
I've had a few problems when I buy frames from like hobby lobby it has no backing on it. I'm fairly intermediate when it comes to cross stitching but I just can't figure out how to frame properly. The frames I get are generally roundish and just the frame itself nothing else. Any advice would be greatly appreciated.
Re: framing
Posted: Mon Dec 10, 2012 9:15 am
by Reta
You need a piece of Acid Free board cut to the size you want to fit the frame
Then stretch the finished piece over it
Instructions
http://www.squidoo.com/how-to-stretch-m ... e140950711" target="_blank
Re: framing
Posted: Mon Dec 10, 2012 9:25 am
by dawnnelson69
Thank you Reta, I'm reading a little bit of the site now and it looks very informational. It looks like I've found a new way to frame, thank you again so much.
Re: framing
Posted: Mon Jun 06, 2016 6:42 am
by ChristineHinderer
These instructions for stretch mounting are nice and clear.
I think I can do this.
I am new to this site and I really enjoy the ability to search for keywords.